Home > Products > AMT ACC3 Mono

AMT ACC3 Mono

Endorsed artists using this product

Frank Marocco
Julien Labro

This product is especially suited for

Accordion

Listen and watch:

	AMT Audio Overview.
	A brief audio overview of AMT.
	Dan Willis - Place Of Enlightenment
	Dan Willis band in a studio with Ron Oswanski on Accordion with the ACC3 and the AMT WS on Oboe.
	ACC3 Right Hand Microphones!
	Listen to the ACC3 with two mic's in the right hand cover the reed blocks evenly.
	Frank Marocco - ACC3
	AMT Endorser Frank Marocco using the AMT ACC3 live. Thanks to Frank for the files!
	Marty Paglione Pod Cast with Tony Miceli
	Tony interviews Marty about some technical issue's related to AMT Microphones and technical information in general. Microphone bleed, rejection rate, etc etc..
	Julien Labro
	Julien's using the AMT ACC3 setups.

Polar pattern

Frequency Response

Pre-amp

The ACC3 is a multi condenser 3 microphone system for accordion. The system contains the latest components in micro electronics. The ultra low mass makes placement easier than other systems on the market today. The system comes with with the "Nano Blend" belt pack.

Housing most of the electronics outside of the accordion makes installation less complicated. With fewer holes to drill, it is easier and more dependable over many years of use. The battery is changable outside of the accordion because it is located in the belt pack. It's small size and low mass gives the end user the ability to permanently or temporarily mount the microphone without major modifications to the accordion.

The ACC3 comes with a wiring harness allowing installation of the bass mic through the bellows and mounted close to the bass machine. Some modification maybe necessary to accommodate the third microphone.

The system is best suited for mic level inputs (PA systems) but also works with line level amps. Both ACC1 & ACC3 will be wireless capable, able to be interfaced with major brand wireless products. The 9 volt battery life for operation is between 80-120 hours of intermittent use before replacement. The output of this system is activated by the quarter inch AMT ACC3 Nano Blend Belt Pack

jack output when plugged in.

The ACC3 Mono version has mixing capabilites right on the belt pack. The belt pack has two gain controls to adjust the volume of the right hand microphones in relation to the left hand microphones. Both hands terminate to a 1/4 inch standard patch cable. The belt pack also has trim filters. The trim filters only cut the highs / and or lows for both the right and left hand independently. You cannot boost highs or lows, this features is designed to help the players with feedback in certian rooms.

Use it with...

Piano Accordions
Button Accordions
Chromatic Accordions
Free Bass Accordions
12 Bass - 120 Bass Accordions
Cajun Accordions

Specifications:

Element	Condenser
Polar Pattern	Omni
Frequency	20Hz - 20kHz
Sensitivity	-64dB+ 3dB
Impedance	600 Ohms*
Power	9 volt battery
Max input SPL	132 dB
Mic Dimension	.375 X .50
Cable	6'
Weight	Mic only: 11 grams Per mic

Comes with:

    * AMT ACC3 Microphones (Three)
    * Nano Blend Belt Pack Preamp.
    * Installation Kit Includes:

3 Individual microphones. 2 - Right hand, 1 - Left hand.

1 Nano Blend Belt Pack Preamp.

1 Output connector Jack with nut. Mounts to grill.
1 Coil Cable to extend Left hand microphone through bellows.
2 L Shaped Brackets mounts inside the bellows.
1 Disconnecting circuit board that junctions all wires together.
1 1/8 inch cable. (Connects accordion to the belt pack.)

Wood screws. (Used only if needed for securing microphones and / or L brackets.

Wireless Ability:

The AMT ACC3 can be used in conjuction with guitar wireless transmitters that have a 1/4 inch plug on the end.

Other:
A typcial setup is for an ACC3 mono or stereo with a 120 bass accordion is to place two microphones in the grill and one microphone in the compartment which houses the bass machine. A wire / signal is wired from the left hand and into the right hand or grill side. In some situation, accordion players have no need to provide amplification for the left hand. If this is the case, during the install, you can choose to not wire the left hand with microphones. Instead you could either place the third microphone into the grill of the accordion to accompany the Right hand microphones or just choose to not install the single left hand microphone at all.

If the player has two accordions, it is possible to fit two seperate accordions with wiring and microphones and use the same belt pack. A common choice is for the player to have a mono and a stereo system, wiring two seperate accordions the exact same way. At this point, the player then has there choice of using the mono or stereo belt pack.

ACCORDION SYSTEM F.A.Q.

AMT ACC3 Mono in use...

Accordion